The Flux Cored Arc Welder Technical Certificate of Credit introduces students to and provides instruction in flux cored arc welding practices. Topics include an introduction to the welding industry, oxyfuel cutting techniques, and flux cored arc welding practices.
Students may enter the Flux Cored Arc Welder program any semester. A full-time student can complete this program in 1 semester. To graduate, students must earn a minimum of 15 semester credit hours.
Employment Outlook
Career Traits/Requirements
Individuals wanting to enroll in the Flux Cored Arc Welder program must have good eyesight, manual dexterity, hand eye coordination, critical thinking skills, problem solving skills, math skills, and the ability to apply technology to the work environment.
Employment Opportunities
Graduates are prepared for entry-level jobs in the welding profession.
Program Costs
Tuition & Fees: $1,831.00
Books & Supplies: $590.00
(Costs are estimated and are subject to change.)
HOPE Career Grant: The HOPE Career Grant, formerly known as the Strategic Industries Workforce Development Grant, is available to HOPE Grant-qualified students who enroll in select majors specifically aligned with one of 12 industries in which there are more jobs available in Georgia than there are skilled workers to fill them. To qualify, an OFTC student must be fully admitted to the college, enrolled in one of the above programs and receiving the HOPE Grant for the same term. The amount of the HOPE Career Grant award is a fixed amount for each term of enrollment:
- 9 or more credit hours – $500/semester
- 3-8 credit hours – $250/semester
- 1-2 credit hours – $125/semester
- Commercial Truck Driving – $1,000 one time award
High School students in dual enrollment and joint enrollment are NOT eligible.
Admission Requirements
OFTC may accept a student’s official entrance score on the following validated assessment instruments if the scores meet the required minimums:
- COMPASS/ASSET,
- SAT,
- ACT,
- PSAT,
- PACT,
- Accuplacer/Accuplacer Next Generation/Companion,
- HOPE GPA after completion of 10th grade of 2.6 or higher, or High School GPA of 2.6 (for occupational programs), or 2.0 for Workforce Entry Level programs, or GED.
The College may accept transfer credit for other courses according to the College’s transfer policy.
Curriculum
Occupational Courses
| WELD 1000 | Introduction to Welding Technology | 4 | 90 |
| WELD 1010 | Oxyfuel and Plasma Cutting | 4 | 90 |
| WELD 1153 | Flux Cored Arc Welding | 4 | 90 |
XXXX XXXX
| Occupational Elective | 3 | |
Program Pathway
Semester 1